Temp Humi/Climate Test Chamber

UP-6111 rapid-rate thermal cycle chamber

UP-6111 rapid-rate thermal cycle chamber(图1)UP-6111 rapid-rate thermal cycle chamber(图2)UP-6111 rapid-rate thermal cycle chamber(图3)UP-6111 rapid-rate thermal cycle chamber(图4)

rapid-rate thermal cycle chamber

Product Paramenters

Item

Specification

Internal Dimension (W*D*H)

1000*800*1000mm

External Dimension (W*D*H)

1580*1700*2260mm

Working Capacity

800 liter

Material of Internal Chamber

SUS#304 stainless steel, mirror finished

Material of External Chamber

stainless steel with paint spray

Temperature Range

-20~+120

Temperature Fluctuation

±1

Heating Rate

5/min

Cooling Rate

5/min

Sample Tray

SUS#304 stainless steel, 3pcs

Testing Hole

diameter 50mm, for cable routing

Power

three-phase, 380V/50Hz

Safety Protection Device

leakage
  over-temperature
  compressor over-voltage and overload
  heater short circuit

Insulation material

Compound material without sweating, special for low pressure

Heating Method

Electrical

Compressor

Imported new generation with low noise

Safety protection device

Protection for leakage
  Over-temperature
  Compressor over voltage and overload
  Heater short circuit

Product Description

This chamber is ideally suited for specimen test requiring quick changes of temperature. It can evaluate the failure of thermal
mechanical properties of product. Normally, the temperature rate is less than 20
/min, which can achieve the real application
environment of testing sample by the fast ramp rate.

TEMPERATURE RAMP SYSTEM (HEATING & COOLING)

Item

Specification

Cooling Speed (+150~-20)

5/min, non-linear control   (without loading)

Heating Speed (-20~+150)

5/min, non-linear control (without loading)

Refrigeration Unit

System

air-cooled

Compressor

Germany Bock

Expansion System

electronic expansion valve

Refrigerant

R404A, R23

APPLICATION

1. To simulate test environment with different temperature and humidity.
2. Cyclic test includes climatic conditions: holding test, cooling-off test, heating-up test, and drying test.

DESIGN FEATURES OF THE CHAMBER

1. It has cable ports are provided on the left side to allow easy wiring of specimens for measurement or voltage application.
2. The door equipped with hinges preventing auto-closing.
3. It can designed to comply with major environmental test standards like IEC, JEDEC, SAE and etc.
4. This chamber is safety tested with CE certificate.

PROGRAMMABLE CONTROLLER

1. It adopts high-precision programmable touch screen controller for easy and stable operation.
2. Step types includes ramp, soak, jump, auto-start, and end.